WSPR TX Mk2 - M0KMI

G3YHV/G0CJG – WSPR TX Mk2

In early 2021 the design of the SARC WSPR TX Mk2 commenced after a quick requirements gathering and a “wish list” from club members.   The hardware has been redeveloped by Colin G3YHV who created the first version of the TX. The software has jointly been developed by Colin and Dave G0CJG.  The software now supports Type 1 and Type 2 message formats and controlled by a user setting.

Build Documentation – SARC WSPR TX Construction v1.3

SARC WSPR TX v2
SARC WSPR TX v2

Detailed below are the features of the Mk2 version of the project and differences from the original TX.

  • PCB – move to commercial production
  • Display – upgrade from 16×2 character display to monochrome OLED SSD1306 i2c module
  • Time – replaced UBLOX GPS module with DS3231 real-time clock battery backed module
  • DDS – AD9850 retained due to frequency range
  • PA – upgrade from single transistor to new PA design
  • Power Output – 3 power settings up to 100mW 
  • PIC Chip – 18F1320 8k + 8Mhz oscillator to 18F26K22 64k + 64Mhz oscillator
  • Bands – 80-10 including WARC bands
  • Software – major change from a user pre-programmed configuration to user defined Setup and User menus where all key parameters can be changed/set
    • Callsign
    • Locator
    • Clock (need only be set once unless battery replaced)
    • Single/3 band hopping
    • Output Power 0-23dBm
    • Tune up mode (TX for 45 seconds)
    • Set TX % on time
    • Set Band
    • Set Screenmode (invert display and change brightness)
    • Calibrate DDS
    • Calibrate TX Drive levels
    • Reset NVRAM settings
WSPR TX2 - M0KMI
WSPR TX2 - M0KMI
WSPR TX2 - M0KMI

Click here for more information about WSPR